Description: Introducing the Fromel Tube PCB Mod for Blues Jr: Unlock the Full Potential of Your Beloved Amp!You cherish your Blues Jr, and now it's time to take it to new heights. The Fromel Tube PCB is the solution to maximize your amp's performance, regardless of its version, from Made in USA to the cathode biased IV. Experience a profound improvement in tone, feel, and noise reduction with the new Tube PCB Mod. We've fine-tuned every detail to deliver unparalleled sonic excellence. Mods from Stock: A cathode follower driven tone stack creates a smooth, compressive vintage feel. The stock Blues Jr leaves one of the gain stages in V2 unused, we use this for the cathode follower. The tone stack loads the signal down a lot, the cathode follower helps recover that signal while adding some musical compression. Cathode biased for a touch responsive playing experience. Prior to the current version of the IV all Blues Jr’s were fixed bias and run hot if not modified. Changing from fixed to cathode bias solves all the bias issues for the amp and it sounds fantastic. DC elevated heaters virtually eliminate noise, pushing the boundaries of silence. When we installed the first prototype, we were astonished by how quiet the amp was; I honestly don’t know why every amp maker does not do this to the heaters, it’s very simple and works incredibly well. We've included a special mod to tame reverb noise because the amp was so quiet after the mods the reverb was irritatingly noisy even at 3, it’s a real easy mod, just clip one cap and we added it to the newest version of out our Supreme mod instructions and recommend it for all Blues Jr’s modded or not. High-quality double-sided through-plated board sets for durability. The stock board is single sided and the PCB mounted tube sockets are only secured by one pad and a bit brittle lead free solder. After a couple of tube changes the stress can crack these joints and this is one of the well known failure points on these amps. These boards are double sided and plated through so the solder joint is very secure. All the traces on the PCB are the equivalent of 18 gauge wire. There is a ground plane to further reduce noise. Pre-soldered resistors, capacitors, and diodes make installation a bit quicker. I put all the instructions right on the PCB and there are detailed instructions with photos online. The ribbon cables are replaced with individual pre-stripped leads. I bought a wire stripper, should have done that years ago. The kit also includes high quality ceramic sockets. I have been working on this mod for a long time and it turned out fantastic. It’s a great improvement to any model Blues Jr with or without the Supreme mods for the main board.
Price: 99.95 USD
Location: Seattle, Washington
End Time: 2024-03-21T19:25:49.000Z
Shipping Cost: 7.49 USD
Product Images
Item Specifics
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: Fromel Electronics
Model: Blues Jr
Amplifier Type: Combo
Power: 15 W
